The clearomizer of the excellent Q16 Pro kit from Justfog is available alone!
Its 16mm diameter has a capacity of 1.9ml and is intended for a MTL vape (tight draw).
Its shape and its long drip tip concentrate the aromas with each puff and offer a steam loaded with flavors.
At the heart of the clearomizer Q16 Pro, you will find a resistance in nichrome 1.6 Ohm compatible with high levels and salts of nicotine. In addition to offering a perfect reproduction of flavors, they are very economical.
Very easy to use, it requires almost no maintenance. It is therefore perfect to begin the vape in perfect conditions!
Little brother of a long sibling, the Q16 Pro clearomizer gains even more simplicity and comfort of use. Intended for a MTL vape (tight draw close to the cigarette), its capacity of 1.9ml is fully secure. It has a leak-proof base and a very clean filling system that is done by unscrewing the top cap (upper part of the clearomizer). You will access the filling notch located on the side (especially not in the middle), fill and close.
Its shape, associated with a drip tip 510 elongated, will concentrate the flavors up during the draw. Thus, you will enjoy a light vape full of flavors.
At the heart of the clearomizer Q16 Pro, you will find the resistance Serie 14 1.6 Ohm. These nichrome resistors are very energy efficient and produce a clean and very fast heating. They are best used between 6 and 12 watts.
When the resistor is worn out (about 3 weeks depending on your consumption), just follow these steps to replace it, and get back to the magic of the beginning!
Unscrew the base of the upper part of the clearomizer, remove the resistance by unscrewing it and insert the new one. Close and insert your liquid Remember to wait a few minutes for the resistor to soak properly.
Capacity: 1.9ml
Resistance: OCC Bottom coil / 1.6 Ohm
Dimensions: ø16x60mm / 16g
1 clearomizer Q16 Pro
1 resistance Q16 of 1.6 Ohm
1 instructions for use
Forbidden under 18 years old
Wishlist
