Vilter pro cartridges from Aspire compatible with the Vilter pro pod kit and the Vilter pro vape pen. The Vilter pro replacement cartridge will make your life easier, because you can change e-liquid in a flash! Also, it comes in replacement of a worn tank or a burned coil. Be careful, when your coil is damaged, you must change the entire cartridge.
Its drip tip filter in PET and paper imitates the filter of the classic cigarette for an easier transition to the vape. You can also use a delrin drip tip (sold separately).
This 2 ml PCTG magnet cartridge offers you an ultra tasty MTL tight draw. You can use nicotine salts, CBD and high nicotine levels. 1 version exists: of 1.2 ohm in kanthal AF (more information below). Prefer a ratio PG / VG 50/50 to 80/20. The filling is done on the side.
Sold by pack of 2.
The pack of 2 Vilter pro cartridges allows to switch more easily and quickly e-liquid to vary the pleasures. But also, this tank will replace a cartridge or a worn coil. Know that the coil is directly integrated into the tank and therefore it is the whole cartridge that is to change when the coil is damaged.
The Aspire Vilter pro cartridge is compatible with the kit pod Vilter pro and the vilter pro vape pen.
The models of Vilter pro Aspire cartridge are as follows:
- Vilter pro cartridge 1.2 ohm (kanthal AF): tight MTL draw - to be used between 8 and 10 watts - ratio 50PG/50VG to 80PG/20VG - compatible nicotine salts, CBD and high nicotine rate.
The drip tip filter in PET and paper mimics the filter of the classic cigarette for an easier transition to vape. You can also use a delrin drip tip (sold separately).
The cartridge Vilter pro Aspire 2 ml is filled from the side easily. To do this, remove the cartridge from the battery, then the silicone cap. Prefer an eliquid ratio 50PG/50VG to 80PG/20VG.
When the coil is damaged, it is the whole cartridge that you have to change. You just have to unclip the tank and clip on another one Attention, when you change cartridge, do not throw the delrin drip tip of your old cartridge. It is necessary to change your cartridge about every 2 weeks depending on your use. Remember to replace your cartridge when you change flavour or you feel a burnt taste.
- 2 Vilter pro cartridges of 2 ml with built-in coil of 1.2 ohm
- 2 PET and paper filters
Forbidden under 18 years old
Wishlist
