Xtank replacement cartridges from Vaporesso

The pack of 2 Xtank cartridges allows you to switch more easily and quickly e-liquid to vary the pleasures. But also, this tank will replace a worn cartridge.

With what equipment to use the replacement cartridge Xtank?

The Vaporesso Xtank cartridge is compatible with the pod Gen PT60 and the pod Gen PT80S.

What are the characteristics of the cartridge Vaporesso Xtank?

Vaporesso has combined both the filling door and the adjustable airflow ring. This is the only cartridge to use this system! The top airflow prevents leaks. But also, the cartridge is equipped with the SSS anti-leak technology.

The cartridge is compatible with the GTX version 2resistors (sold separately):

- 0.15 ohm GTX coil (mesh): DL overhead draw - to be used between 60 and 75W - ratio 30PG/70VG or 20PG/80VG

- 0.2 ohm GTX coil (mesh): air draft DL (abundant steam and fast heating) - to be used between 45 and 60W - ratio 50PG/50VG to 20PG/80VG - compatible with low nicotine levels (from 0 to 6 mg/ml)

- 0.3 ohm GTX coil (mesh): air draft DL - to be used between 32 and 45W - ratio 50PG/50VG to 20PG/80VG - compatible with low nicotine levels (from 0 to 6 mg/ml)

- 0.4 ohm GTX coil (mesh): RDL draw - to be used between 26 and 32W - ratio 50PG/50VG or 30PG/70VG or 40PG/60VG

- 0.6 ohm GTX coil (mesh): RDL draw (balance between flavors and steam) - to use between 20 and 30W - ratio 50PG/50VG or 30PG/70VG or 40PG/60VG - compatible nicotine rate from 0 to 9 mg/ml

- 0.8 ohm GTX coil (mesh): RDL draw - to be used between 12 and 16W - ratio 50PG/50VG - compatible nicotine rate from 0 to 18 mg/ml

- 1.2 ohm GTX coil (regular): MTL tight draw - to be used between 8 and 12W - ratio 50PG/50VG to 80PG/20PG - compatible with nicotine salts, CBD and high nicotine levels (from 0 to 18 mg/ml)

Thus, you can enjoy an air draw DL, RDL or tight MTL according to your preferences. These coils have a triple silicone to prevent leakage of eliquid.

How to use the Xtank cartridge?

The Xtank cartridge of Vaporesso 4.5 ml is filled on the side easily. To fill, you just have to turn the airflow ring and open the silicone cap. To change the magnetic cartridge, you just have to unclip the tank and clip on another one. To change the coil, remove the cartridge from the pod and then the damaged coil. Prime a new coil and insert it before filling the tank, repositioning the cartridge and waiting 10 minutes to vape.

Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavour or if you feel a burnt taste.