Cartridges TG (Cyber G) - Aspire | x2 Pack
The TG (Cyber G) cartridges from manufacturer Aspire become one with the Cyber G and Cyber G Slim pods to offer you quality vaping. By owning TG spare cartridges, your daily vaping life will be greatly simplified and the flavours of your e-liquids preserved because they allow you to change liquids by simply switching cartridges. The resistors are built into the TG cartridges, so it's essential to have a small stock to spare so you don't get trapped by a worn-out coil.
The TG cartridges offer a 3 ml capacity, which is generous for cartridges intended for MTL use. Given that we're dealing with a tight draw, nicotine salts, CBD, standard e-liquids with low or high nicotine levels are invited, as long as you're on a PG/VG ratio of around 50/50 it plays. The e-liquids will go in on the side and stay nicely wisely in the leakproof tank made of PCTG.
Sold in packs of 2.
Aspire TG replacement cartridges
The 2-pack of TG cartridges allows you to vary your e-liquids with disconcerting ease. What's more, TG replacement cartridges will answer your SOS in the event of a damaged tank or worn-out resistor. It would be silly to spend a whole weekend at the mother-in-law's house without being able to vaper, which is the best way to relight a cigarette. Bear in mind that the coil is built directly into the tank, so it's the entire cartridge that has to be changed when the coil is damaged.
With what equipment should you use the TG replacement cartridge?
These cartridges are compatible with Aspire's Cyber G and Cyber G Slim pods.
Find all the compatible gear in the list of complementary products.
2 versions available for the Aspire TG cartridge
The TG cartridge models are as follows:
- TG 0.8 ohm cartridge (Mesh): Slightly air MTL draw - 60PG/40VG to 50PG/50VG ratio - Nicotine rate up to 20 mg/ml.
- TG 1.0 ohm cartridge (Mesh) : Tight MTL draw - ratio 70PG/30VG to 50PG/50VG - Nicotine rate up to 20 mg/ml (CBD e-liquids compatible)
Filling the TG cartridge:
- Remove the cartridge from the battery (magnetic system).
- Open the silicone tab, fill, then close.
- Put back the cartridge on the battery.
Replace your TG cartridge:
- Remove the used cartridge from the battery (magnetic system).
- Install a new cartridge in its place.
- Caution: If the coil is new, prime it well by letting it soak in e-liquid for 10 minutes before vaping.
Beware, you need to change your cartridge approximately every 2 weeks depending on your usage. Remember to replace your coil when you change flavour or smell a burnt taste.
- Capacity (ml)
- 3ml
- Type of inhalation
- MTL
- Airflow
- Bottom Airflow
- Fill type
- Side Filling
- Packaging
- Pack of 2 units
- Compatible coils
- Built-in coil
- Country of manufacture
- made in China
Complementary products
Forbidden under 18 years old