Cartridges ITO - Voopoo | Pack x2
The ITO cartridges of Voopoo are compatible with the pods Doric 20, Drag Q and Doric 20 SE. The ITO cartridges will be useful to vary the flavors throughout the day by simply changing the cartridge. The coils are directly integrated into the ITO cartridges, once a burnt taste arises, it is the whole cartridge that must be changed.
The ITO coils have proved their worth in terms of flavors, find them now directly integrated into cartridges to gain in convenience.
These cartridges have a PCTG tank of 2 ml to fill on the side by removing the silicone cap. You will enjoy a tight MTL draw with the 1.0 ohm and 1.2 ohm versions, then you will have the opportunity to opt for a more airy vape with the 0.7 ohm version.
Sold in packs of 2.
ITO replacement cartridges from Voopoo
With this pack of 2 ITO cartridges, switching from a gourmand e-liquid to a polar mint has never been so easy. Know that the coil is directly integrated into the tank, so it is the whole cartridge that is to change when the coil is damaged. Be prepared, always have a few cartridges on the replacement bench.
With what equipment to use the ITO replacement cartridges ?
The Voopoo ITO cartridges are compatible with the pods Doric 20, Doric 20 SE and Drag Q pods from Voopoo.
Three versions of Voopoo's ITO cartridge are available
The ITO cartridge models are as follows:
- ITO cartridge 0.7 ohm: MTL tight draw, nice vapor production - ratio 50PG/50VG to 40PG/60VG - compatible with nicotine salts but do not exceed 10 mg/ml. 9 mg/ml maximum for standard e-liquids.
- Cartridge ITO 1.0 ohm: MTL tight draw - ratio 70PG/30VG to 50PG/50VG - compatible nicotine salts, CBD and high nicotine rate.
- Cartridge ITO 1.2 ohm: MTL very tight draw, discrete vapor - ratio 70PG/30VG to 50PG/50VG - compatible nicotine salts, CBD and high nicotine rate.
Regardless of the version, the ITO cartridges will offer a tasty steam thanks to the use of mesh resistive delivering a homogeneous heating.
How to use the ITO cartridge?
Voopoo ITO cartridges are equipped with a 2 ml PCTG reservoir that you can fill from the side by removing the silicone cap that covers the filling hole. If the cartridge is new, let it sit for 10 minutes so that the resistance is impregnated with e-liquid.
To change the cartridge, it's even easier, you unclip the cartridge to reclip a new one.
Attention, it is necessary to change your cartridge about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or you feel a burnt taste.
- Capacity (ml)
- 2ml
- Type of inhalation
- MTL
- Airflow
- Bottom Airflow, Non-adjustable
- Fill type
- Side Filling
- Packaging
- Pack of 2 units
- Compatible coils
- Built-in coil
- Country of manufacture
- made in China
Complementary products
Forbidden under 18 years old