Wenax M1 Cartridges - Geekvape | x4 Pack

2ml MTL

New versions

Wenax M1 Cartridges - Geekvape | x4 Pack

Wenax 1 cartridges from Geekvape compatible with the pod Wenax M1 and the Pod Refill by Pulp. If you are the kind of indecisive and can not confine yourself to a single e-liquid, then these cartridges will allow you to change flavor in a clipse and especially without mixing the liquids. In addition, it allows you to replace a tank worn or a coil to breath. The coils are integrated, so if the coil is damaged, the whole cartridge must be replaced.

This cartridge has a 2 ml PCTG tank which offers a tight MTL draw thanks to its integrated 0.8 ohm coil. This allows you to use nicotine salts, CBD e-liquids and high nicotine levels. The filling of the cartridge is done on the side by removing the cartridge from the pod.

Sold in packs of 4.

2ml MTL

Product Description

Geekvape Wenax M1 replacement cartridges

This pack of 4 cartridges Wenax M1 allows you to switch easily and quickly e-liquid to vary the pleasures without mixing the flavors. But also, they will replace a cartridge or a worn coil. Know that the coil is directly integrated into the tank and therefore it is the whole cartridge that is to change when the coil is damaged.

With what equipment to use the replacement cartridge Wenax M1?

The Geekvape Wenax M1 cartridge is compatible with the Geekvape Wenax M1 pod and the Pod Refill by Pulp.

1 version available for the Geekvape Wenax M1 cartridge

- Cartridge Wenax M1 0.80 ohm: MTL draw - ratio 60PG/40VG to 50PG/50VG - compatible with nicotine salts, CBD and high nicotine rate.

With their PCTG tank of 2 ml, Wenax M1 cartridges offer a good capacity for use in MTL draw. They are equipped with a non-adjustable bottom airflow and clip in a single pressure on their battery.

How to fill your cartridge Wenax M1 of Geekvape :

Remove the cartridge from the pod.
Remove the silicone cap and fill with e-liquid.
Close the cap and put the cartridge on the pod (let the coil soak in e-liquid for ten minutes if the cartridge is new).

How to replace your cartridge Geekvape Wenax M1 :

Remove the cartridge from the pod by pulling it.
Clip another cartridge.

Attention, it is necessary to change your cartridge about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or you feel a burnt taste.

Technical characteristics