Cartridge Zyon - Innokin | 4,5 ml

Zyon replacement cartridge by Innokin:

With a few small Zyon cartridges to spare, you can change e-liquid flavours in a simple swap or simply replace a damaged tank. The Zyon cartridge features a bottom-fill system that will allow you to pour up to 4.5 ml of e-liquid into its tank.

With which equipment to use the Zyon replacement cartridge?

The Zyon cartridge from Innokin is compatible with the pod Zyon, find it in the list of complementary products.

What coils for the Innokin Zyon cartridge?

The Zyon cartridge works with Innokin's PZP coils.

Caution: The 0.4 ohm PZP coils are not compatible with the Zyon pod.

• PZP coils 0.4 ohm : DTL/RDL draw - for use between 30W and 40W - PG/VG ratios from 50/50 to 30/70 - Recommended nicotine levels up to 6 mg/ml.
• PZP coils 0.6 ohm : RDL/MTL draw - for use between 18W and 24W - PG/VG ratios from 50/50 to 40/60 - Recommended nicotine levels up to 12 mg/ml.
• PZP coils 1.0 ohm: MTL draw - for use between 9W and 13W - Ratios PG/VG from 70/30 to 50/50 - Recommended nicotine rates up to 20 mg/ml.
• PZP coils 1.2 ohm: MTL draw - for use between 10W and 13W - Ratios PG/VG from 80/20 to 50/50 - Recommended nicotine rates up to 20 mg/ml.

Filling the Zyon cartridge:

• Remove the cartridge from the battery.
• Open the silicone tab, fill and then close again.
• Place the cartridge back on the battery.

Replace the Zyon cartridge resistor:

• Unclip the cartridge from the battery.
• Remove the worn coil by pulling on it.
• Insert a new coil with a simple press.
• Caution: If the coil is new prime it well by letting it soak in e-liquid for 10 minutes before vaping.

Warning, it is necessary to change your resistance about every two weeks depending on your use. Remember to replace your coil when you change flavour or smell a burnt taste.