HW-T Coils - Eleaf | Pack x3

HW-T coils from Eleaf

Eleaf has not been idle in the creation of these coils. With each puff, a propeller located in the center of the coil will engage thanks to the airflow to allow cooling the resistive kanthal mesh but also to push the projections of e-liquid on the cotton of the coil and not at the bottom of your throat.

With what equipment to use the HW-T coils?

The HW-T coils are compatible with the following tanks:

- Rotor

- Ello / Ello Mini / Ello TS / Ello Vate / Ello Duro (you will find the Ello Duro in the iJust 3 kit).

The different models of Eleaf HW-T coils:

- HW-T Mesh Kanthal 0.20 ohm: DL draw - to use between 40 and 90 watts - ratio 40PG/60VG to 0PG/100VG - Prefer liquids not exceeding 6 mg/ml of nicotine.

How to use Eleaf HW-T coils?

To change your coil HW-T, simply remove the base of your clearomizer Rotor or Ello to screw a new coil. Soak the openings of eliquid with a new coil and let stand 15 minutes in a full tank before vaping.

Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or you feel a burnt taste.