The Sceptre coils have been specially designed for the Sceptre pod kit from Innokin and the Sceptre cartridge. The coil 0.5 ohm RDL is perfect for direct inhalation (air draft - DL), but also the production of steam. The coil 1.2 ohm MTL is ideal for indirect inhalation (tight draw - MTL), the good restitution of flavors and the use of nicotine salts. The coil 0.65 ohm is specially dedicated to a tight draw MTL.
Regarding the composition of the eliquid, prefer a ratio 50/50 PG / VG or 70/30 PG / VG (for the coil 1.2 ohm and 0.65 ohm) and up to 70 VG (for the coil 0.5 ohm RDL). You should know that changing the coil is very easy, because you just have to rotate the base of the cartridge and unscrew the used coil before replacing it.
This is a 5 pack of coils that you can buy today.
You own the Innokin Spectre pod kit and/or the Spectre cartridge of the same brand? Opt for the Spectre replacement coils in 0.5 ohm, 0.65 ohm or 1.2 ohm. With the pack of 5, you will not run out of coils and therefore vape. In addition, they are in an eco-responsible packaging to limit the impact on the planet.
There are 3 models of coils Sceptre Innokin :
- Sceptre 1.2 ohm: You prefer indirect inhalation (tight draw - MTL)? Then the coil Spectre 1.2 ohm MTL is perfect! The program? Excellent restitution of flavors! Know that with this coil, you can use your nicotine salts. This one is compatible with a power between 9 and 10 W.
- Sceptre 0.65 ohm: perfect for a tight draw MTL and use between 9 and 12W.
- Sceptre 0.5 ohm: Indirect inhalation is not for you and you like direct inhalation (air draw - DL)? The Sceptre 0.5 ohm RDL coil is ideal! Especially since it promotes the production of steam. Use it between 18 and 20 W.
Replacing the coil is very easy. To do this, simply rotate the base of the cartridge, remove the used coil by unscrewing and finally insert the new coil. Do not forget to replace the base and fill with eliquid(ratio 70/30 PG / VG or 50/50 PG / VG for the coil 1.2 ohm and 0.65 ohm and up to 70 VG for the coil 0.5 ohm). We advise you to wait a few minutes before vaping in order not to damage the coil prematurely. Why? To allow time for the coil to soak in eliquid.
Simply, use your resistances with :
- Innokin Sceptre Pod
- Innokin Sceptre MTL Pod
- Innokin RDL/MTL Sceptre Cartridge
- Innokin Sceptre MTL Cartridge
- Innokin Sensis Pod
- Innokin Sensis Cartridge
Forbidden under 18 years old
Wishlist
