SPL 10 Mesh coils by Nevoks

Guaranteeing long-term performance is the watchword of Nevoks manufacturers!

SPL 10 coils are designed to be perfectly leak-proof and dry-hit free through special manufacturing processes, high temperature testing. The high quality cotton and evenly heated resistive wire ensure an extremely long life.

What equipment should I use the SPL 10 Mesh coils with?

The SPL 10 Mesh coils are compatible with pods from the Feelin range, as well as the Pagee Pod. Check out all the compatible devices in the “complementary products” tab.

The different models of Nevoks SPL 10 Mesh coils

The models of SPL 10 Mesh coils are as follows:

• SPL 10 1.0 ohm (Mesh) : MTL draw - to use between 10W and 13W - PG/VG ratio from 70/30 to 50/50 - Nicotine content up to 20 mg/ml (CBD e-liquids compatible).
• SPL 10 0.8 ohm (Mesh) : MTL draw - to use between 15W and 18W - Ratio PG/VG from 60/40 to 50/50 - Nicotine rate up to 20 mg/ml.
• SPL 10 0.6 ohm (Mesh) : RDL draw - to use between 18W and 25W - PG/VG ratio from 50/50 to 40/60 - Nicotine rate up to 12 mg/ml.
• SPL 10 0.4 ohm (Mesh) : RDL draw - to use between 25W and 35W - PG/VG ratio of 50/50 to 30/70 - Nicotine rate up to 6 mg/ml.
• SPL 10 0.3 ohm (Mesh) : DTL draw - to use between 30W and 40W - PG/VG ratio of 50/50 to 30/70 - Nicotine rate up to 6 mg/ml. (use only with Feelin X pod)

How to change the SPL 10 Mesh coils?

To change the coil, remove the cartridge from the battery, then the damaged coil. Prime a new coil and place it. Finally, fill and wait 10 minutes before vaping.

Be careful, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavour, or you feel a burnt taste.