Si vous ne fumez pas, ne vapez pas
Coil ITO Voopoo compatible with the kit Doric 20W, the ITO cartridge, the pod Drag Q, the cartridge ITO-X Voopoo.
The mesh technology of coils promotes the production of steam, but also the excellent restitution of flavours of e-liquids. 3 models available: 0.5 ohm, 1.0 ohm and 1.2 ohm (more information below).
MTL tight vape for exceptional flavours or RDL.
Sold by box of 5 units.
Buy a pack of 5 replacement ITO coils from Voopoo. The mesh technology promotes both flavour and vapor production.
The ITO coils are compatible with the doric pod kit 20W, the iTO cartridge the drag Q pod the iTO-X cartridge of Voopoo.
The models of coils ITO Voopoo are the following:
- ITO M0 0.5 ohm (kanthal mesh): RDL vape - To use between 18 and 25 watts - Ratio 50PG/50VG
- ITO M2 1.0 ohm (kanthal mesh): MTL tight vape - For use between 10 and 14 watts - Ratio 80PG/20VG to 50PG/50VG - Compatible with high nicotine rate, CBD and nicotine salts
- ITO M3 1.2 ohm (kanthal mesh): MTL tight vape - To use between 8 and 12 watts - Ratio 80PG/20VG to 50PG/50VG - Compatible with high nicotine rate, CBD and nicotine salts
Changing the coil is very simple with a pull-and-push system. Just pull the old coil, prime the new one and push it into the slot. Before vaping, wait 10 minutes.
Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavour or if you feel a burnt taste.
Wishlist
Welcome on Freevap !
This site is reserved for adults. To access our store, please confirm that you are 18 years or older by entering your date of birth.
The sale of vaping products and electronic cigarettes is strictly prohibited to minors. By entering this site, you accept our terms and conditions and confirm that you are of legal age to consume these products in your country of residence, namely Switzerland.
