Do you own the AVP Cube pod kit fromAspire? Then also buy the replacement cartridge for this vape. So you can change e-liquid simply by changing the cartridge or replace a worn cartridge.
This 3.5 ml cartridge is easy to use just like the pod. The filling is done from below and the change of resistance uses the pull-and-push system. Moreover, it is compatible with the AVP Pro resistors of Aspire 0.65 ohm and 1.15 ohm to vary the vape experience.
Cartridge sold individually
This 3.5 ml cartridge is compatible with the aspire AVP cube pod kit. Make a stock of replacement cartridges in case the tank is worn out. But also, to vary the pleasures by switching cartridges and therefore the various flavors.
From the top of its 3.5 ml, the cartridge Aspire is easy to use. Indeed, the filling from below is very convenient. You just have to remove the cartridge from the battery and lift the silicone cap. After filling, close the silicone seal, replace your cartridge with the powerful magnet and wait a few minutes so that the resistance has time to soak in e-liquid
The AVP cube cartridge of Aspire is used with the aVP pro resistances kanthal of the same brand. There are 2 models:
- 0.65 ohm: to use between 15W and 18W - more air - ratio 50PG/50VG
- 1.15 ohm: to use between 10W and 16W - tighter draw - Possibility of using a high nicotine rate and nicotine salt - ratio 70PG/30VG
To change the resistance, remove the cartridge from the battery, pull on the coil, place another and replace the cartridge. Warning, wait a few minutes before vaping.
Anonymous A. published the 18/05/2021 following an order made on 01/05/2021
good product , i bought it to have it as spare.
Forbidden under 18 years old
Wishlist
