Cartridge Ursa pro - Lost Vape | 7 ml

7ml DTL Bottom Airflow Addable accessories
  • Special offer
Cartridge Ursa pro - Lost Vape | 7 ml
Cartridge Ursa pro - Lost Vape | 7 ml
Complementary products

You just bought the pod kit Ursa Quest Multi 100W? Also get the Ursa pro cartridges from Lost Vape.

With a capacity of 7ml, these cartridges are designed in transparent PCTG which will allow you to see your eliquid level at a glance. The Ursa pro cartridges are compatible with UB pro 0.15 and 0.3 ohm resistors and have an 810 drip-tip that you can replace as you wish

The cartridges are intended for an air vape (DL) and is fixed very quickly via a lock system. The filling is done in a very simple way on the side (side-filling). With the airflow ring (not included), you can easily adjust your airflow

Sold per unit without heater

7ml DTL Bottom Airflow Addable accessories Side Filling

Ursa pro 7 ml replacement cartridge - Lost Vape

7 ml replacement cartridge for the ursa Quest Multi pod kit from Lost Vape. Made of PCTG, this cartridge is suitable for a DL (direct inhalation) air draw for large vapor clouds. The airflow is adjustable with the airflow ring the airflow is adjustable from a very airy draw to a tighter draw according to your needs. This ring is screwed on the cartridge. So, if you want to replace the tank, it is important to remove this Ursa airflow base and place it on the new cartridge. This pod is equipped with a drip tip 810.

What are the resistors compatible with the cartridge Lost Vape Ursa pro (not delivered)?

The Ursa pro cartridge is compatible with mesh resistances UB pro of Lost Vape (not delivered) offering an excellent restitution of flavors and large clouds of steam:

- The UB Pro P1 resistor 0.15 ohm (Ni80): DL air vape - to use between 70 and 90 watts - ratio 30PG/70VG

- The UB Pro P3 resistor 0.3 ohm: air vape DL - to use between 60 and 75 watts - ratio 30PG/70VG

To change the resistance, press at the same time the 2 buttons with an arrow, on each side of the pod while pulling slightly upwards. Then, remove the damaged resistance, prime a new one and insert it in its place. Wait a few minutes before vaping.

The fans of rebuildable will also be able to use the base RBA UB pro Lost Vape.

How to use the cartridge Ursa pro Lost Vape?

The filling is done on the side (side-filling) without the need to remove the cartridge. Just remove the silicone cap. The transparency of the tank allows you to see the level of e-liquid remaining

The cartridge is equipped with an innovative lock to clip which allows the proper connection between the tank and the battery. To change the cartridge, press simultaneously the 2 buttons with the arrow engraving, located on each side of the pod Remember to remove the airflow ring Ursa.

Capacity (ml)
7ml
Type of inhalation
DTL
Airflow
Bottom Airflow, Addable accessories
Fill type
Side Filling
Compatible coils
UB pro coils
Country of manufacture
made in China
Imported by
PLAYSURE SA

Complementary products

- 20% CHF5.90
CHF4.72
In stock
Tax included

Free delivery from 29,90CHF purchase
If you don't smoke, don't vape

close

Wishlist