The Nautilus Prime X cartridge fromAspire is available in 2 models. Here, it is the model of 4 ml for BP coils and BP RBA tray. Thus, you get more versatility. But also, this one has an anti-leakage system that will delight all vapoteurs
It is made of PCTG for excellent strength. Make a stock of cartridges to switch easily from one e-liquid to another or simply replace a worn tank.
Filling the tank and changing the resistor is easy.
Sold individually without resistance
The replacement cartridge for the Nautilus Prime X of Aspire is available in 4 ml BP model. This one will allow you to switch easily and quickly from one e-liquid to another or replace a worn out tank. The replacement tank offers more versatility (DL and MTL). It even has an anti-leak system.
The 4 ml BP cartridge is made of nylon and PCTG. It is compatible with bP coils resistance of Aspire
- BP mesh resistor of 0.17 ohm: very airy draw DL - to use between 45 and 55W - Ratio 50PG/50VG or 30PG/70VG
- 0.3 ohm BP mesh resistor: air draft DL - to be used between 30 and 40W - Ratio 50PG/50VG or 30PG/70VG
- 0.6 ohm BP resistor: RDL restrictive air draft - to be used between 15 and 25W - Ratio 50PG/50VG or 30PG/70VG - High nicotine rate (0 to 12 mg)
- 1.0 ohm BP resistor: tight draw MTL - to be used between 10 and 16W - Ratio 50PG/50VG or 70PG/30VG - Very high nicotine rate (0 to 18 mg)
For fans of reconstructible, it is possible to add the bP RBA tray on the cartridge for a rebuildable vape (sold separately).
The tank is filled from the side by lifting the silicone tab after removing the cartridge from the pod. The ratio PG / VG will depend on the resistance installed. To change the resistance, remove the cartridge from the pod, then simply pull the damaged resistance. Prime the new coil and insert it into its slot. Wait a few minutes before vaping after replacing everything.
Forbidden under 18 years old
Wishlist
