Cartridges Veego 80 - Nevoks | Pack x2

3,5ml MTL DTL RDL Bottom Airflow Adjustable

Special offer

The Nevoks Veego 80 cartridge is only compatible with the Veego 80 pod/mod from the same brand.

Buy the pack of 2 replacement cartridges Veego 80. Thus, you can easily and quickly change e-liquid or replace a worn out tank.

The PCTG tank can hold up to 3.5 ml of e-liquid. Filling is easily done from the top by lifting the silicone cap. The Nevoks cartridge is compatible with mesh resistors SPL 12 (sold separately) of 0.17 ohm, 0.3 ohm and 0.6 ohm.

Sold in packs of 2 without resistance.

3,5ml MTL DTL RDL Bottom Airflow Adjustable Top Filling

Product Description

Nevoks Veego 80 2-pack of cartridges

Buy the Veego 80 Nevoks replacement cartridges to switch in a flash from one eliquid to another or change a worn out tank. These are only used for the nevoks Veego 80 pod/mod.

The Nevoks Veego 80 cartridge: a versatile, flavorful all-rounder

The Veego 80 kit offers a tight MTL / RDL or DL draw. Incredible! The flavors will be exceptional. You can modulate the airflow by adjusting theairflow located at the base of the tank

The PCTG cartridge can accommodate up to 3.5 ml of e-liquid This one is sold without coil. However, it is compatible with the following SPL 12 Nevoks resistors:

- SPL 12 resistor of 0.17 ohm (mesh): DL draw - to be used between 40 and 60W - ratio 50PG/50VG to 30PG/70VG

- SPL 12 resistor of 0.3 ohm (mesh ): RTL draw - to be used between 30 and 50W - ratio 50PG/50VG to 30PG/70VG

- SPL 12 0.6 ohm mesh resistor: MTL tight draw - use between 15 and 25W - ratio 50PG/50VG to 70PG/30VG - compatible with high nicotine levels, CBD and nicotine salts

Mesh technology promotes both flavor and vapor production. SPL coils are designed to be perfectly leak-proof and eliminate dry-hits through special manufacturing processes and high temperature testing. The high quality cotton and evenly heated resistive wire ensure an extremely long life.

How to use the Nevoks Veego 80 tank?

The Nevoks cartridge is easily filled from the top by lifting the silicone cap. To change the coil, remove the cartridge from the battery, then the resistance. Prime a new coil and place it in its slot. Clip on the cartridge, fill and wait 10 minutes before vaping.

Technical characteristics