- New versions
Si vous ne fumez pas, ne vapez pas
Cartridges Wenax K1 - Geek Vape | Pack x3
Cartridges Wenax K1 - Geek Vape | Pack x3
CHF8.90
In stock
Tax included
Wenax K1 cartridges from Geekvape compatible with Wenax K1, Wenax K1 SE and Wenax K2 pods.
This pack of three replacement cartridges Wenax K1 allows you to change the liquid in a clip to vary the flavors throughout the day according to your mood. Moreover, the coils being directly integrated in the cartridges, in case of a little tired coil, it is always good to have a small stock to replace it.
The Wenax K1 cartridges are equipped with a 2 ml PCTG tank to be filled on the side. Available in three versions (0.8 ohm, 1.0 ohm and 1.2 ohm), Wenax K1 cartridges offer you different tight draw sensations (MTL) and are compatible with nicotine salts and high nicotine levels.
Sold in packs of 3.
Geekvape Wenax K1 replacement cartridges
The pack of three cartridges Wenax K1 allows to change easily and quickly e-liquid to vape different juices, morning, noon and evening. They can also replace a tank or a damaged coil. Know that the coil is directly integrated into the tank and therefore it is the entire cartridge that is to change when the coil is damaged.
Equipped with a tank of 2 ml PCTG, Wenax K1 cartridges are filled on the side and will offer an excellent flavor in indirect inhalation.
With which material to use the Wenax K1 replacement cartridges ?
Wenax K1 cartridges are compatible with :
- The wenax K1 pod.
- The Wenax K1 SE pod.
- The wenax K2 pod.
The Wenax K1 cartridge from Geekvape exists in three versions:
The models of Wenax K1 cartridge of Geekvape are the following:
- Wenax K1 cartridge 0.80 ohm : MTL draw - to be used between 12 and 16 watts - ratio 60PG/40VG to 50PG/50VG - compatible nicotine salts and high nicotine rates.
- Wenax K1 1.0 ohm cartridge: MTL draw - to be used between 12 and 14 watts - ratio 70PG/30VG to 50PG/50VG - compatible with nicotine salts, CBD and high nicotine levels.
- Wenax K1 1.20 ohm cartridge: very tight MTL draw - to be used between 10 and 12 watts - ratio 70PG/30VG to 50PG/50VG - compatible with nicotine salts, CBD and high nicotine levels.
How to fill your cartridge Wenax K1:
- Remove the cartridge from the battery.
- Open the silicone tab.
- Fill with e-liquid.
- Close the tab.
- Put the cartridge on the pod.
- Let stand for ten minutes before vaping if the cartridge is new
How to replace your cartridge Wenax K1 :
- Remove the cartridge from the battery by pulling it.
- Clip a new cartridge.
Attention, it is necessary to change your cartridge about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or when you feel a burnt taste.
- Capacity (ml)
- 2ml
- Type of inhalation
- MTL
- Airflow
- Bottom Airflow, Non-adjustable
- Fill type
- Side Filling
- Compatible coils
- Built-in coil
- Country of manufacture
- made in China
- Labels
- New versions
