ITO Cartridges without coil 3 ml - Voopoo | Pack x2

3ml MTL RDL Pack of 2 units

Voopoo here offers us an ITO cartridge that can now hold 3 ml of e-liquid. You'll be able to use these cartridges with Doric pods (except for the Doric 60). These are empty cartridges, so this pack of two cartridges allows you to replace a worn-out tank. Unsurprisingly, these ITO cartridges are compatible with Voopoo's ITO coils (sold separately).

These cartridges are designed with a transparent PCTG tank for excellent visibility of your e-liquid level and thus avoid an infamous dry-hit. As for filling, it's simply done on the side of the cartridge. At the top is a slim, comfortable drip tip, well suited to MTL or RDL vape.

Sold in packs of two without resistance.

3ml MTL RDL Side Filling Pack of 2 units

Product Description

3ml ITO replacement cartridges without coils from Voopoo:

These ITO cartridges let you introduce up to 3ml of e-liquid. They feature a slim, proprietary drip tip designed for MTL or RDL use. These are cartridges without coils, it will be necessary to fit them with ITO coils (sold separately) in order to use them on your Doric pod.

The 3 ml ITO cartridges are notably compatible with Doric pods (except the Doric 60). Find all the compatible gear in the “complementary products” list.

What resistors for my 3 ml ITO cartridges?

These cartridges work with the following ITO coils, so you can enjoy an excellent vape in MTL indirect inhalation or RDL restricted direct inhalation.

ITO M0 0.5 ohm : RDL draw - 18W to 25W - PG/VG from 50/50 to 30/70 - Recommended nicotine rate up to 12 mg/ml.
ITO M1 0.7 ohm : RDL draw - 14W to 18W - PG/VG from 50/50 to 40/60 - Recommended nicotine rate up to 12 mg/ml.
ITO M2 1.0 ohm : MTL Draw - 10W to 14W - PG/VG from 70/30 to 50/50 - Recommended nicotine rate up to 20 mg/ml.
ITO M3 1.2 ohm : MTL draw - 14W to 18W - PG/VG from 80/20 to 50/50 - Recommended nicotine rate up to 20 mg/ml.

ITO cartridge refill:

Remove the cartridge from the battery.
Open the silicone tab on the side of the reservoir, fill and then close.
Put back the cartridge on the battery.

Replacing the resistor on the ITO cartridge:

Remove the cartridge from the battery.
Insert the resistor under the cartridge.
Put back the cartridge on the battery.
Attention: If the coil is new, prime it well by letting it soak in e-liquid for 10 minutes before vaping.

Attention, it is necessary to change your resistor about every fortnight depending on your use. Remember to replace your coil when you change flavour or smell a burnt taste.

Technical characteristics