Cartridges Spark - Kiwi Vapor | x3 Pack

Spark replacement cartridges by Kiwi Vapor

Make a small stock of cartridges for your Spark pod with this pack of three Spark tanks with integrated mesh coils(non-replaceable). The Spark cartridges can hold up to 2 ml of e-liquid and their quality coils will let you enjoy ultra-satisfying vaping for a long time.

The Spark cartridges can accommodate Kiwi Vapor's cotton filters drip tip or polycarbonate drip tip (sold separately). In addition to the Spark pod, you should know that Spark cartridges are also compatible with the Kiwi 2 pod. Find all the compatible equipment in the list of complementary products at the bottom of the page.

Cartridges sold in sets of three with filter drip tips.

Many versions for different sensations

Kiwi Vapor offers two versions of the Spark cartridge so you can enjoy different MTL (tight draw) vape sensations.

• Spark cartridge 0.8 ohm: Not too tight MTL draw - PG/VG ratios of 70/30 to 50/50 - recommended nicotine levels up to 20 mg/ml.
• Spark cartridge 1.2 ohm: Tight MTL draw - PG/VG ratios of 80/20 to 50/50 - recommended nicotine levels up to 20 mg/ml.

Filling the Spark cartridge

• Remove the Spark cartridge from the battery by pulling on it.
• Open the silicone tab, fill with e-liquid then close.
• Return the cartridge to the battery.

Replacing the Spark cartridge

• Remove the used cartridge.
• Install a new cartridge.
• Caution: if the coil is new prime it well by letting it soak in e-liquid for 10 minutes before vaping.

The resistors are replaced approximately every two weeks depending on your use. As soon as you have a burnt taste or a loss of flavour, your resistor is out of order.