VCAP cartridge by Innokin

Compatible with Innokin's Trine pod kit, the VCAP cartridge will complement or replace your current cartridge. With a capacity of 2 ml, this cartridge features an integrated coil available in several ohms: 0.6, 0.8 and 1.2 ohm. So you can choose between a restrictive RDL or tight MTL vape.

The VCAP cartridge is compatible with the Innokin Trine pod. Find it in the list of complementary products at the bottom of the page.

Cartridge sold individually.

The different VCAP cartridge models

Innokin has developed three versions of the VCAP cartridge. Each has its own unique features. It's up to you to choose what you prefer most, between a tight MTL vape or a slightly airier RDL vapor.

• VCAP 0.6 ohm cartridge: RDL draw - PG/VG ratios from 50/50 to 30/70 - Recommended nicotine levels up to 6 mg/ml - for use between 20 and 22W.
• VCAP 0.8 ohm cartridge: MTL draw not too tight - Ratios PG/VG from 60/40 to 50/50 - Recommended nicotine levels up to 12 mg/ml - to be used between 12 and 14W.
• VCAP 1.2 ohm cartridge: Tight MTL draw - PG/VG ratios from 70/30 to 50/50 - Recommended nicotine levels up to 20 mg/ml (compatible with nicotine salts) - to be used between 11 and 12W.

Filling the VCAP cartridge

• With the VCAP cartridge, you don't need to remove the entire cartridge from the battery.
• Pinch the drip tip with your fingertips and remove it.
• Fill with e-liquid, then reclip.

Replacing the VCAP cartridge

• Remove the old cartridge (magnetic system).
• Install a new cartridge.
• Please note if the coil is new, prime it by letting it soak in e-liquid for 10 minutes before vaping.

Coils should be replaced every two weeks or so, depending on how you use them. As soon as you notice a burnt taste or loss of flavor, your coil is out of order.